After getting and using so so many tanks.
I always seem to come back to my Kanger Tech Pro Tank 2 mini.
Here are the modis I have done.
1. Im using a thick gormet from a used coil base Andy sent me. So it can be rebuilt many times without tearing the rubber.
2. Im using a 30 gauge twisted coil at 1 Ohm. Where you braid two strands of wire.
3. Im using 3mm Silica with cotton. Take your silica and wrap it with a think layer of cotton.
4. Im using the latest adjustable air flow base by Kanger Tech. Not the cheap 5$ deal you see on ebay. Check Baba Vapes for pictures of this.
With this setup. I get better flavor, better smoke than any other tank.
I vape it at 15 watts min.
For this to work you need to vape at 15-20 watts and the juice flow must keep up with the heat. Esle you will get a dry heat.
How do you get a pro tank min to work at 15-20 watts ?. Its all about the juice flow. Watch the you tube videos. Its one tank that is very highly talked about world wide. I love it so much that I have a few back up glass tubes for it. The real deal in proper Kanger Tech packing.
The only down side is it holds 1.6 ML only. But I like that too it means I can switch flavors thru the day.
Between flavors I do a dry burn and then wash in alcohol.
After this my next fav tank would be the iclear 30s. Then the russian, then the dripper then the others.
The problem with the Pro Tank 3 mini is that as long as your using a company coil it works better than the 2. But when it comes to building your own coils. I have not been able to build a decent dual coil setup. I can get it to work but not match a new company coil. And you have to build two coils one on top of the other for this tank. Or it leaks.