So Prd droped by with his new hammer mod. And a few tanks.
A dry tank and an i-atty mini.
First hit oil taste.
So washed and cleaned still oil. So washed again.
Still not impressive.
Then noticed coil was .6 ohms. VTR was driving it.
Then Prd said most people say they have to rebuild the unit to use it.
So rebuilt it.
After much trying gave up on trying to use both wicks and both coils. And switched to a single coil and single wick setup.
All I can say is disappointed. The only thing this setup seems good for is blowing a room full off wape. This much wape is just over kill. It cant be good for your lungs. It cant be good for you.
This is beyond anything you need to enjoy flavor or get your nic fix. This just borders on the absurd. At .6 Ohms my bat did not even last 10 Min.
I will come back to this tank when I get some time. And see what can be done but short off just allowing you to consume copious amounts of liquid and bat. I see no point.
So what is my best tank so far. I think Prd will back me up on this nothing comes close to what you can do with a well setup Pro Tank 2. Agreed it took me 40-50 rebuilds to hit the sweet spot. But man what a spot that is. After the Pro Tank 2 min. The next best would be the Protank 1 I tune for Mukund. Post tuning the leaks stoped and the vape Flavor and hit was spot on. A distant 3rd would be the T2.
What I like about the thin coils is good bat life. Good flavor Good Smoke.
What I hate abou the Genny is the wire mesh wick is silly. If you dont touch the mesh it wont smoke well. If you do touch the mesh it creates hot spots and shorts.
So you need to soak the top of the SS mesh with Silican. Then wrap around it.
My first Genny Exp.
Re: My first Genny Exp.
Im getting better results with a single coil. Than I am with two coils.
Still does not match the protank 2 mini with custom coil.
Guess you really need a mech mod to drive this. Or wait for the segeli.
Tips when winding
a. Wind the coil on a drill bit. In the tank.
b. Chk the ohms without ss rope or ss wire mesh. Say you get 1.4 Ohms. Now install ss rope or wire mesh after you oxidize it by burning it. If using mesh 500 is better than 400. And roll it with a center silica wick.
The ohms should be the same. If the ohms has dropped it means the coil and the wire mesh or rope are shorting out somewhere. The tune is in getting the coil to get as close to the wick without causing a short.
Still does not match the protank 2 mini with custom coil.
Guess you really need a mech mod to drive this. Or wait for the segeli.
Tips when winding
a. Wind the coil on a drill bit. In the tank.
b. Chk the ohms without ss rope or ss wire mesh. Say you get 1.4 Ohms. Now install ss rope or wire mesh after you oxidize it by burning it. If using mesh 500 is better than 400. And roll it with a center silica wick.
The ohms should be the same. If the ohms has dropped it means the coil and the wire mesh or rope are shorting out somewhere. The tune is in getting the coil to get as close to the wick without causing a short.