Mikuni & Kehin Jets for sale.
Posted: Fri Dec 17, 2004 12:19 am
Are you tired of paying thru your nose for Mikuni jets.
Are you tired of the lousy quality and variances in flow rate with after market jets.
Simple fact most workshops in India don’t even know how to correlate size to flow. They only offer two sizes bigger or smaller. How much bigger or smaller depends on the drill bits in the shop.
Did you know the level of accuracy required with drilling jets is 0.0001” does the shop doing your jets even have the equipment to measure 0.01”
Feed up with dealing with these frustrations. We have done our home work and now offer a range of jets for mikuni and Kehin. That are accurate to within 1 Thousandth of an inch.
Only the best quality carbide cutters are used for the job. Not cheap HS drill bits that change their size. As they get used.
Prices are.
Mikuni 2$ Each or Rs 150/- Sizes from 110 to 500+
Kehin 2.50$ or Rs 200/- per jet.
If you would like to drill your own jets. Carbide cutters are avalible for 6-13$ each depending on where you buy them.
Sample of the bits we use. Made in Germany. Imported from the US.
Are you tired of the lousy quality and variances in flow rate with after market jets.
Simple fact most workshops in India don’t even know how to correlate size to flow. They only offer two sizes bigger or smaller. How much bigger or smaller depends on the drill bits in the shop.
Did you know the level of accuracy required with drilling jets is 0.0001” does the shop doing your jets even have the equipment to measure 0.01”
Feed up with dealing with these frustrations. We have done our home work and now offer a range of jets for mikuni and Kehin. That are accurate to within 1 Thousandth of an inch.
Only the best quality carbide cutters are used for the job. Not cheap HS drill bits that change their size. As they get used.
Prices are.
Mikuni 2$ Each or Rs 150/- Sizes from 110 to 500+
Kehin 2.50$ or Rs 200/- per jet.
If you would like to drill your own jets. Carbide cutters are avalible for 6-13$ each depending on where you buy them.
Sample of the bits we use. Made in Germany. Imported from the US.