RDDREAMS.COM

Please give as much as info as possible. Also how it compared to your stock exp.

Todays Build.
Tank:
Aqua with modified drill holes. Drilled the two air holes at the base to 1.85mm
Modified the Derlin with 2mm cutter.
Top Holes drilled out to 2mm each. One hole blocked off.

30 Gauge. At 6 Wraps. For 1.4 ohms.
Mixture off organic cotton + 2.5mm Silica wick.
Coil is wrapped around the silica and cotton. Two of the silic wicks go to the two juice channels in front.
Two of the cotton tails go to the two juice channels at the back. Remember the Aqua has 4 juice channels.
The chimney is modified with a large chamfer leading out into the drip tip.
Adjustable juice control is fully closed.

Improvement in flavor. 50%
Improvement in clouds over stock 100%.
Works well with Mech Mod with laptop bats.
Also works well with itaste at max 15 Watts or 6 Volts. No dry hits.
Flavor tested RY4 Strong. USA

hi ron,

for best flavor do you recommend kayfun lite or orchid?

im using Magma - 1.2ohm + rayon build on MVP 2 at 10 watts and vaping on melon madness quite like it.

should i try to get any of the above or should stick with magma?

Personally I think drippers taste like shit. I thought it would be cool to taste flavors and change flavors but Ive stopped using it for even that.
The kayfun problem is most of the cheap clones dont work well out of the box.
If you set it up right or get an original that would be different.

For Flavor I think The Kayfun, Orchid and Aqua are all pretty close.
While there are small differences between the tanks. I think the orchid will work the best out of the bunch. Out of the box.

I plan to get myself one. Soon. My decision is Fogger 4.1 or Orchid or Rose.
My dream to own all the Kanger Tech tanks is still on. But so far only got the Pro Tank 2 and 3 mini. The 3 is dead no coil. And what I got from Fast Tech was dead on arrival.

The choice of your hardware on the RDA's will make very little effect on the flavor. They all taste good.
But what will make a HUGE effect on the flavor is how you build it. How you mod it.

I was sucking on the Aqua for weeks. Trying all kinds of shit and it was just Meh..
Then today I modded it and did the 1.4 Ohm 30 gauge 4 juice channels cotton silica combo. And it just blew my mind.

I believe the future of vaping is higher and higher watts. With easier Draw.
There should be zero effort when you suck in the air. Tight draws will go out of fashion soon.

i am using authentic Kanger Aerotank. What you suggest for best build?

The Kangers work super out of the box. That is why I feel they are collectors items.

The Aero Tank is a dual coil right ?. So rebuilding it is out of the question. At least Ive not been able to rebuild it.

The only problem with the kangers is you have to stick to one flavor or the taste gets mixed up.

yes. Its dual coil but I have seen some videos on youtube for the rebuild. But I am still struggling for rebuilding the coils.

I really like the kayfun lite plus 1.4 ohm build with 30 guage kanthal (7-8 wraps) with cotton. It gives great vapor and flavor. I am using it on my stingray x with a kick set to 12 watts. If i go to about 1.8 to 2.0 ohm, i dont get enough flavor and the vape is really hot.

I also use the kanger tech aerotank mega and the aspire nautilus, but i like the kayfun the best