Parts for 72 R5C 350
-
lindstrom4200
- Posts: 1
- Joined: Sat Apr 09, 2005 8:30 am
Parts for 72 R5C 350
Last time I had it "running" Only ran on one cyl., I have new points and condensors, coils are good, wires -plugs good, clean carbs, checked compression, way of from one side to the other, what is it supposed to be at?? Think its just gaskets? or am I probly gonna need rings too? lemme know what you think... Thanks !!
Its hard to say.
Reading should be arround 100 PSI. it will start with anything abve 80 PSI.
These are low side numbers.
Lift barrels and check condition of rings, ring end gaps, and piston to liner cleareance also chk for head gasket leak. WHen you have it apart.
Reading should be arround 100 PSI. it will start with anything abve 80 PSI.
These are low side numbers.
Lift barrels and check condition of rings, ring end gaps, and piston to liner cleareance also chk for head gasket leak. WHen you have it apart.
To vilify a great man is the readiest way in which a little man can himself attain greatness.
Edgar Allan Poe
Edgar Allan Poe